SPECIFICATION SHEET • SI METRIC
CAT: WATER-SLURRY
Water Treatment Chemical Dosing
Calculate active chemical mass, prepared solution mass, and dosing-pump volume from water flow, target dose, concentration, and solution density.
OPERATING LIMITS — Chemical feed-rate calculation only; validate jar-test demand, residual targets, solution strength, density, calibration, materials compatibility, injection hydraulics, and handling requirements.
INPUT DESIGN PARAMETERS (SI)
m³/h
mg/L
%
kg/L
CALCULATED SPECIFICATION OUTPUT
Active Chemical Rate
💧24 kg/day
| Prepared Solution Mass | 192 kg/day |
| Dosing Solution Volume | 174.55 L/day |
Related planning checklists
This calculator appears in the following engineering planning checklists:
Water-Treatment Chemical Dosing Check
Environmental Engineer1. Plant Water Balance Calculator2. Wastewater Hydraulic Retention Time3. Water Treatment Chemical Dosing4. Sedimentation Tank Sizing5. Rectangular Tank Volume & Capacity6. Freshwater vs Recycled Water Ratio
Technical Methodology & Engineering Principles
GOVERNING EQUATION
Active chemical per day = water flow × dose; solution mass = active mass / active fraction; solution volume = solution mass / solution density.
Assumptions & Scope
Steady water flow and uniform dosing. Verify jar-test demand, residual targets, chemical compatibility, temperature, calibration-cylinder volume, injection quill hydraulics, and local handling requirements.
Operating Range & Boundary
Use finite, physically meaningful inputs within the stated operating assumptions.